Publicidad
Idiomas disponibles
Idiomas disponibles
3. INSTALLATION
3.1. Installation location
The installation site must meet the following conditions:
• Compliance with standard NF C 15-100:
• Installation in the heated space recommended to ensure optimal thermal performances of the system (if this is
impossible, the product must be installed without fail in a frost-free room where the room temperature does not exceed
40°C).
• As this water heater operates using extract air, it must be ducted and therefore there are no restrictions in the volume
of the installation room
• Stable floor capable of supporting a weight of 350 kg minimum (surface under the water heater) if installed on the floor.
• Level surface essential (condensate discharge).
• For wall mounting, check that the wall can support the weight of the water heater when full of water.
• Enclosed space with soundproofed walls and door.
• Avoid installing the product in the vicinity of sleeping accommodation (acoustic comfort). If this is not possible, install
soundproofing in the cupboard.
• As close as possible to the discharge points to minimise the energy lost through the pipework.
• Check for easy access to the cover fastening screws (front side and lid) for any maintenance work.
• Ceiling height of > 2.3 m necessary to be able to remove the top cover during any repair work (T.Flow Hygro+).
• Minimum surface area needed: dependant on the position and type of water duct, the available width must be adjusted
to guarantee that the product remains operable for servicing.
3.2. Transporting the thermodynamic water heater to the installation location
Remove the plastic packaging, the wooden frame, the bands and the cap on the top of the product.
The accessories supplied are located on the top protection cover (make sure you do not throw them away when unpacking).
List of accessories:
• Easyclip collars x2,
• Pack of 2 dielectric connectors,
• Diaphragm adapter to connect the condensate tube to a 32 mm diameter PVC pipe,
• Installation template (T.Flow
• This guide.
Refer to paragraph 2.5 for handling the water heater.
The water heater must be
installed in space 3 or outside
heated area
Nano)
®
43
Space 3
Space 2
Space 1
60 cm
EN
Publicidad
