Publicidad
Idiomas disponibles
Idiomas disponibles
6.3. Info menu
This involves an information menu, which has no impact on the operation of the thermodynamic water heater. It is used to
understand the estimated electricity consumption levels (total, fan only and DHW heating only) and the condition of the filter.
It can also be used to reset these data (especially when the filter is replaced, see paragraph 7.2).
The thermodynamic water heater will continue to operate in the selected mode whilst the info menu is being consulted.
Press the "+" and "-" keys simultaneously to enter the info menu.
The Info menu ("i" circled) pictogram displays at the bottom right of the LCD screen.
The filter state indicator lamp displays at the top right of the screen and remains there as
long as the Info menu is active.
When the Info menu is consulted whilst the filter verification "alert" is triggered, a proposal
to reset the filter clogging indicator lamp is displayed.
Otherwise, the total tank consumption is displayed in the centre of the screen.
With the "+" and "-" keys, the user can consult the other consumptions and bring up the
reset proposals.
The consumption values display automatically when selected.
When resetting consumptions,
Press the OK key to confirm the request (the meters reset to 0).
Press the "+" and "-" keys simultaneously again to leave the info menu. The menu is left
automatically if the keypad is not used for a certain time.
6.3.1. Resetting the filter indicator lamp
Enter the info menu by pressing on the "+" and "-" keys to reset the filter state indicator
to zero (after changing a filter).
Use the "+" or "-" keys until the filter reset request appears on the screen.
Press the OK key.
The screen displays a confirmation request.
Press the OK key again to confirm the reset.
57
and
Filter
Filter
Filter
kWh
and
AUTO
kWh
Filter
and
and
or
Filter
EN
Publicidad
