Arktic SLUSH MACHINE 2X12L Manual Del Usuario página 13

Intended use
• This appliance is designed for dispensing cold beverages. Any
other use may lead to damage of the appliance or personal
injury.
• Operating the appliance for any other purpose shall be
deemed a misuse of the device. The user shall be solely liable
for improper use of the device.
Grounding installation
This appliance is classified as protection class I and must be
connected to a protective ground. Grounding reduces the risk
of electric shock by providing an escape wire for the electric
current.
This appliance is fitted with a power cord with grounding plug
or electrical connections with grounding wire. The connections
must be properly installed and grounded.
Main parts of the product
(Fig.1 on page 3)
1. Bowl lid cover
2. Bowl
3. Control panel
4. Detachable Drip tray
5. Grid
6. Float (overflow indicator)
7. Dispenser taps
8. Handles
9. Feet
Spare parts
A. Auger seal hat cover x3
B. Bowl seal ring x1
C. Dispenser tap seal ring x10
D. Auger shaft white washer x3
E. Auger shaft black washer x3
F. Tube of lubricant x1
Control panel
(Fig.2 on page 3)
10. Bowl indicator light
11. Display
12. Mode selection button for desired bowl
13. Right panel
14. Increase hardness + / Temperature
15. Display of hardness / Temperature
16. Decrease hardness - /Temperature
17. Left panel
18. Granita mode indicator
19. Juice mode indicator
20. OFF mode indicator
21. Power switch
22. Parameter setting button
(See == > Parameter Setting of the Machine)
23. Illumination light button
Circuit diagram
(Fig.3 on page 4)
T. Switch power
M1: Compressor
FA: Compressor overload
KA: Compressor relay
C: Start capacitor
M2: Condenser fan motor
DPF1\DPF2: Electronic expansion vavle of 1\2
NTC1\NTC2: Sensor of drink of 1\2
NTC3\NTC4: Sensor of suction of 1\2
WX: Temperature display
MI \MII : DC Gear Motor of 1\2
LEDI \LEDII : LED Lights of 1\2
Preparation before use
• Remove all protective packaging and wrapping.
• Check to make sure the appliance is undamaged and with
all accessories. In case of incomplete delivery and damages.
Please contact supplier immediately. Do not use the appli-
ance.
• This machine should be checked for its function properly by
specialized trained personnel.
• Clean the appliance before use (See == > Cleaning & Main-
tenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
NOTE: Due to manufacturing residues, the machine may emit a
slight odor in the first few cycles. This is normal and does
not indicate any defect or hazard. Make sure the machine
is well ventilated.
Operating instructions
a) Preparation of the food ingredient:
(Fig.4 on page 4)
• Dilute and mix the CONCENTRATE with WATER in a suitable
container, following the manufacturer's recipes. THE MIX-
TURE OBTAINED MUST HAVE A MINIUM SUGAR CONTENT
OF 13°BRIX. A lower concentration may damage the augers
and/or gearmotors.
• WARNING! The temperature of the food ingredient should
never exceed 25°C.
• WARNING! Never use only with water.
b) Putting food ingredient into the machine:
• WARNING! Food ingredient should be poured into the bowl
(2) only when the machine is OFF and unplugged from the
electrical power supply.
• To remove the bowl lid (1) of the bowl (2), follow these instruc-
tions (Fig.5 on page 4):
1) Lift the rear part of the lid;
2) Extract the bowl lid (1) from the retainer placed at the front
side.
• Pour the food ingredient (G) into the bowl (2) with care and not
beyond the "MAXIMUM LEVEL". (Fig.6 on page 4), (Do not pour
hot liquid to avoid hazard.)
• After pouring/refilling the food ingredient into the bowl (2),
close the bowl lid (1) on top of the bowl (2). (Fig.7 on page 4)
WARNINGS!
1. Never switch on the machine if the bowl lid is missing. Before
removing the bowl lid, switch off the machine and unplug it.
2. There are some moving parts inside the bowl, which
may cause injuries, switch off the machine and un-
plug it before carrying out any operation.
GB
13