Charging Instructions - Juice BOOSTER 3 AIR Manual Del Usuario

Operating instructions
⚠ C A U T I O N
•
Use your charging equipment exclusively at power
sockets and charging stations for which you have original
JUICE mains adapters. The device charges your vehicle
with single- or three-phase AC voltage ranging from 6 to
16 ampere. Use only original JUICE accessories equipped
with the original JUICE CONNECTOR.
•
Protect your charging equipment against damage from
being run over, dropped, yanked, kinked or crushed.
•
To prevent overheating while charging, do not expose
your JUICE BOOSTER 3 air to direct sunlight or other
sources of heat for long periods of time. If the JUICE
BOOSTER 3 air becomes overheated, charging is
automatically interrupted until the unit's temperature
drops to within its normal operating range.
•
In many countries, industrial power outlets must be
equipped with a Type-A residual current device (FCD).
JUICE recommends that a Type-A FCD be installed in
power sockets of any kind. Please note the regulations
in the country of use, as these always take precedence.
As the JUICE BOOSTER 3 air is already fitted with a
built-in DC residual current monitor, you don't have to
bother with pricey installation of a Type-B FCD or
Type-A power supply
Operating panel on the charger device
PHASE AMPERE
0 6 8 10
STANDARD NORWAY
FRANCE EARTH CHECK OFF
3 sec.
MODE
Select button for charging status/mode
PHASE: Indicates the number of phases detected in the
mains charging current and the number of phases used
during charging.
AMPERE: Displays the automatically set or individually
reduced amperage value (i.e. the current amperage).
MODE: Indicates the preselected mode.
LINK: Displays the active radio interfaces.
FAULT: Displays the cause in the event of a fault
(see table at the end).
25
1 sec.
LINK
13 16
network
BOOSTER SOCKET WIRING
CAR NO EARTH OVERLOAD
FAULT
User Manual JUICE BOOSTER 3 air [JTJB3-EU2R*] V 1.1
Chase light: Indicates the ongoing charging operation
(flashing speed varies with the charging power).
On the back of the device you'll find a How-To quick-start
guide, hazard warnings, the unit's serial number and other
product information.
Function button on the vehicle-end
connector
A button is fitted to the back of the vehicle-end connector
of the JUICE BOOSTER 3 air. This button functions as a
standard feature in the same way as the identical Select
button on the operating display of the JUICE BOOSTER 3
air. If you have linked the JUICE BOOSTER 3 air with the j+
pilot app on your smartphone, you can assign other or addi-
tional functions provided they are activated for your device.
Find out more about this in the j+ pilot app.
RFID reader on the vehicle-end
connector
The RFID reader on the vehicle-end connector is always
activated. To activate the charging process, hold a pre-
viously registered RFID card up to the RFID symbol on
vehicle-end connector. Your device comes with two cards
that are ready to be activated in the app.
To register an additional RFID card or tag of your choosing
(MIFARE Classic), connect your JUICE BOOSTER 3 air with
your j+ pilot app and follow the given instructions.

Charging instructions

HOT
RCD
⚠ D A N G E R
Always perform charging operations in the specified
order of steps.
•
Always stop the charging process before you remove
the charger vehicle-end connector from the vehicle
charger socket.
•
Never disconnect any plug (neither from the power
socket, nor on the JUICE CONNECTOR) while the
charging process is ongoing.
•
Potential charging faults (FAULT) are identified on the
device's function display. (further information in this
regard can be found in the Fault indications table).