Juice BOOSTER 3 AIR Manual Del Usuario página 28

reader on the vehicle-end connector. When
activation is successful, the chase lights flash first
from right to left, and then from left to right before
cutting out.
7
The charging process begins automatically.
The chase light flashes from left to right
during charging. The flashing speed varies,
depending on the charging power current intensity.
8
The charge process ends.
When the chase light stops flashing, the vehicle has
properly completed the charging process.
If charging at first fails to start automatically, it's possible
that a timer setting in the vehicle or app has scheduled
charging for a certain specific time of day.
Changing the charging current
amperage (AMPERE)
•
Press the SELECT button (before plugging the
vehicle-end connector into the vehicle charging socket,
or within 30 seconds after plugging it in).
When the Change mode is activated, the
charging current level flashes in white.
•
By pressing the button again, the ampere value decreas-
es by one level. Press the
times as necessary until the LED is at the desired
amperage.
•
Pressing the button again after position 6 amperes
causes the LED to jump back to the maximum value
defined by the given adapter in use.
•
We recommend reducing the charging current intensity
when charging from older installations or continuously
charging from household power sockets. This may also
be necessary if multiple e-cars are being charged at
outlets that share fuses, or where the outlets are fused
for and specifically state lower amperage values.
•
For safety reasons, the charge intensity cannot be
increased beyond the charge intensity determined by
the JUICE BOOSTER 3 air.
•
The selected setting will be saved automatically after
approx. 5 seconds.
27
SELECT button as many
User Manual JUICE BOOSTER 3 air [JTJB3-EU2R*] V 1.1
The LED displays the selected ampere
value in solid white.
•
The JUICE BOOSTER 3 air saves the last charge
intensity setting used with a particular mains adapter,
and that setting is restored after any power interruption
or when the device is plugged in again with the same
adapter
Changing the operating mode (MODE)
•
Press and hold down the
3 seconds (before plugging the vehicle-end connector
into the vehicle charging socket, or within 30 seconds
after plugging it in).
When the Change mode is activated, the
current setting flashes in white/yellow.
•
Set the desired operating mode by pressing the
SELECT button repeatedly until the desired mode is
reached. Sequence: Standard – Norway – France –
France+Earth Check Off - Earth Check Off
The selected setting will be saved
automatically after approx. 5 seconds. The selected
mode is displayed in white.
STANDARD mode
For operation in all countries except France and Norway.
FRANCE mode
This mode must be selected for charging in France (as it
limits the Schuko plug to 10 A or 8 A/ 14 A for GreenUp).
NORWAY mode
This mode, and only this mode, must be selected for charg-
ing in Norway (configures the device for use in earth-free
IT networks).
⚠ D A N G E R
EARTH CHECK OFF MODE
Disables the device's internal earth conductor check. The
earthing is not interrupted in the process. This mode may
only be used once you have checked to verify that the
electrical installation and earthing have been correctly
connected.
Unbalanced loads and other inadequacies in the grid can
result in the earth conductor check detecting an irregular-
ity with the earthing despite it being correctly connected.
For technical reasons, this circumstance cannot be re-
Select button for approx.