Juice BOOSTER 3 AIR Manual Del Usuario página 33

Fault indications (FAULT)
Function display
Possible cause
/ LED
BOOSTER
Initialisation error
BOOSTER +
Initialisation of the RCD
RCD
protection function in the
device has failed
CAR
Error on the car
SOCKET
Fault in the power socket or
feeder line
SOCKET +
JUICE CELSIUS sensor
HOT
in the adapter reports
overheating
NO EARTH
No earth wire detected at
the mains outlet
WIRING
The mains power socket has
been incorrectly connected.
OVERLOAD
Your vehicle is drawing more
current than is set on the
JUICE BOOSTER 3 air.
OVERLOAD
Incorrect Type-2 adapter
+ SOCKET
(32 A) connected
HOT
The device has overheated
RCD
FI circuit breaker has been
triggered
User Manual JUICE BOOSTER 3 air [JTJB3-EU2R*] V 1.1
Action
Disconnect the JUICE BOOSTER 3 air from the vehicle and the mains Restart
the process. Charge your vehicle at other power outlets and locations. If the
same error recurs: Stop using the device and contact JUICE Customer Service.
If this fault occurs repeatedly in succession: Contact JUICE Customer Service
and have the device checked.
Check your vehicle and the vehicle connection socket. Restart the complete
charging process. If the same error recurs, contact a vehicle specialist.
Check whether the JUICE CONNECTOR has been firmly plugged in until an
audible click is heard.
Check the electrical installation, mains plug, adapter and JUICE CONNECTOR
for damage and/or corrosion; have any damage repaired.
The power socket has overheated, charging is temporarily suspended. Once
the power socket has cooled down, charging will begin again at the next lower
power level. This process will repeat three times before the charging process is
aborted entirely. Check the connected power socket and mains plug for damage.
Do not charge your vehicle at this installation. There is a risk of electric shock.
Read also the section on "Changing the operating mode (MODE).
For your safety, charging will not start. Notify the electrician responsible for
the installation. Refrain from using this socket for any other devices, too. These
hazards pose a mortal danger!
Charging has been suspended for your safety. Start your vehicle (if possible), and
then restart the charging operation. If this fails to resolve the problem, contact
your vehicle manufacturer.
You have connected the Type-2 adapter of the JUICE BOOSTER 3 air, which is
set for 32 A (= 22 kW), but the charging device is designed for 16 A (= 11 kW).
For safety reasons, the charging operation cannot be started. To use your JUICE
BOOSTER 3 air as a Mode-3 charging cable, please use the Type-2 adapter
for the JUICE BOOSTER 3 air, recognisable by the yellow dot on the JUICE
CONNECTOR.
If the JUICE BOOSTER 3 air overheats, the charging power is reduced. If
necessary, the charging process is suspended until the temperature falls below
a specific threshold value. Wait until the JUICE BOOSTER 3 air restarts the
charging process automatically once the device has cooled down. Do not leave
the device exposed to sunlight, but also do not cover it.
Disconnect the JUICE BOOSTER 3 air from the vehicle. Wait until the fault
automatically resets and the fault indicator is no longer flashing. Restart the
charging process. Charge your vehicle exclusively from individually fused power
sockets. If this fault occurs repeatedly in succession: Have your vehicle checked
by your vehicle service garage.
32