Juice BOOSTER 3 AIR Manual Del Usuario página 27

•
Vehicles fitted with a Type-2 charging socket lock the
charge coupling during the charging process, and the
coupling remains locked as long as the car is locked.
This protects the JUICE BOOSTER 3 air against theft.
•
Should any unauthorised party disconnect the
mains-end cable from the power socket during the
charging process, when the cable is reconnected to the
socket the charging process will automatically continue
at the most recently detected or manually reduced
charge current intensity.
Vehicle-end charging connection
Please consult the vehicle user manual for information
on plugging in the connector, locking and unlocking the
coupling, stopping the charging process, unplugging the
connector from the vehicle-end socket, and the status of
charging and the connection at the vehicle.
Changing out the mains-end adapter
⚠ D A N G E R
•
Stop the charging process.
•
Before changing the mains adapter plug, always first
disconnect the vehicle-end connector from the vehicle
and the mains adapter from the power socket.
•
Always change out the mains adapters in a dry place.
The adapters are connected and disconnected via the
JUICE CONNECTOR safety connection:
1
JUICE CONNECTOR safety plug
(leads to the JUICE BOOSTER 3 air)
2
1
2
JUICE CONNECTOR safety coupling
(part of the adapter)
3
Plug and press together until you hear a click.
User Manual JUICE BOOSTER 3 air [JTJB3-EU2R*] V 1.1
4
3
5
Important: Ensure that you hear and feel the
connection snap into place! Mechanical guides
only allow connection in the correct position
(orange dots provide orientation for correct alignment).
4
Disconnect the connectors by pulling back the
retaining ring on the JUICE CONNECTOR safety coupling.
This is part of the adapter.
5
Protective end caps (always fit the caps in place when
the device is not in use, as they protect against ingress of
dust, moisture and other harmful substances). The JUICE
CONNECTOR is only watertight when fully plugged in.
Charging from domestic or industrial
power outlets
1
Select the fitting mains adapter.
2
Connect the JUICE CONNECTOR of the JUICE
BOOSTER 3 air to the JUICE CONNECTOR of the mains
adapter, as described above.
3
Plug the mains connector into the power source
socket.
Chase lights signal the self-test by
flashing first from left to right, and then from right
to left before cutting out.
4
The device is ready for operation within approx. 3
seconds.
The detected charging current (AMPERE)
and number of phases (PHASE) as well as
the set operating mode (MODE) are illuminated in
white.
5
Check to ensure the charge current intensity is correct.
Note: The charge intensity can be reduced within the first
30 seconds after connecting the JUICE BOOSTER 3 air
to the vehicle by pressing the
6
Plug the vehicle-end connector into the vehicle's
charge-port socket.
Without activation: When the vehicle is
successfully recognised, the chase lights flash first
from right to left, and then from left to right before
cutting out.
With RFID activation: Hold your
previously registered RFID card up to the card
SELECT button.
26