GYS SMARTFEED M-4 Manual De Instrucciones página 16

TORCH TYPE CONFIGURATION AND TORCH WIRING
1- Torch without motor (default setting):
- Determination of the torch type via DIP SWITCH:
2- Torch with DC 42V motor, without encoder:
- Determination of the torch type via DIP SWITCH:
or
- Determining the type of torch via wiring:
3- Torch with 36V BRUSHLESS motor, 500pts encoder:
- Determination of the torch type via DIP SWITCH:
or
- Determining the type of torch via wiring:
WIRING OF THE TORCH
Pin Name
1 Phase 3
2 Phase 2
3 Phase 1
4 GND
5 5Vdc
6 HALL_A
7 HALL_B
8 HALL_C
9 GND
10 5Vdc
11 A
12 B
13 GND
14 24Vdc
15 Collision signal
16 Reverse signal Wire
17 Advance signal Wire
18 Signal EV GAZ
19 GND
20 10Vdc
21 IN 4
22 Detect_PP
23 Type_Mot
24 Signal EV AIR
16
SMARTFEED M-4 / MB-PP
BRUSHLESS
Phase 3 (motor supply)
Phase 2 (motor supply)
Phase 1 (motor supply)
Hall Effect Sensor
Encoder
500pts
Collision sensor
Dry contact between 24vdc and collision signal
Dry contact between GND and Reverse wire signal
Dry contact between GND and wire feed signal
Dry contact between GND and EV GAZ signal
Torch selection
Dry contact between GND and EV AIR signal
1 2 3 4
Set positions 1, 2 and 3 to OFF
ON
1 2 3 4
Set positions 1 and 3 to OFF.
Set position 2 to ON.
ON
1
Attach pin 22 (DETECT_PP) and pin 9 (GND) of the
24-pin connector together at the torch connector.
24
3 4
1 2
Set position 1 to OFF..
Set positions 2 and 3 to ON.
ON
1
Attach pins 22 (DETECT_PP), 23 (MOTOR_TYPE)
and 9 (GND) of the 24pts connector together at
the torch connector.
24
Function
DC
(-) Motor (motor supply)
(+) Motor (motor supply)
EN