Frigomat MIX8 Manual De Uso Y Mantenimiento página 50

REMOVING AND CLEANING COVER
• Pull the hinge pin off and remove the cover, holding it with both hands.
Emerge the previously disassembled components into the tub with the sanitizer and
brush the surfaces with care. Pay special attention to the surfaces in direct contact with
the product.
21 - ENGLISH
Pour the maximum admitted load of cold drinking
water into the tub to rinse the surfaces which were
just treated with the sanitizer.
• Drain the rinse water and turn the machine off.
• When pre-washing is over, all the removable parts in
contact with the product must be disassembled and
sanitized in a separate tub.
SANITIZING REMOVABLE PARTS
PREPARATION OF WASHING TUB
• Wash your hands well and/or wear disposable
gloves.
• Fill a clean tub with a sufficient amount of drinking
water at approximately 50°C and the sanitizer.
We suggest using the following sanitising
solution:
Ecolab P3 Topax-san
(4% dilution = 200 ml every 5 litres of water).
• Prepare the supplied brush and the OR disassembly
device and immerse them in the solution.