Blackstar Amplification AMPED 3 Manual Del Propietário página 9

control (35). The USB stereo line input will also be affected by the Level control
when it is monitored through the Line Out.
NOTE: This signal is taken after the Master volume control.
Ring
Tip
Screen
32. CabRig Switch
Use this to switch between the three CabRig settings currently stored on your
AMPED 3. You can customise the three factory patches using the CabRig section
of Blackstar's Architect software.
33. Level - CabRig Outputs
This control allows quick access, physical control over the XLR, Line Out and USB
audio channel 3 output level. At maximum (fully clockwise), this control has no
effect on the signal level. At minimum (fully anti-clockwise), this control attenuates
the signal on these outputs by 20dB.
34. Kensington Lock
Also known as a Kensington Security Slot or K-Slot this is a specifically sized hole
for connecting a compatible Kensington Lock to secure the amplifier to a fixed
point. For more information please refer to www.kensington.com
Architect
Amplifier
On this page all of the front panel (outlined in the 'Front Panel' section of this
manual) controls of your AMPED 3 can be adjusted.
To switch to CabRig page in Architect, click on the CabRig icon at the bottom of
the page. Please see the CabRig section below for more information on CabRig.
16
Right channel
to mixer
Left channel
to mixer
Saving Patches
Click on the 'Save' icon in the toolbar to save an amp Patch. In the pop-up window,
you can choose to "Save Patch to Device" or "Save Local Patch". All amplifier front
panel settings will be saved for either option.
Clicking "Save Patch to Device" will save a
Device Patch. Device Patches are stored on
your Amped 3 and can be recalled using
the Channel Footswitches (see 1 - Channel
Footswitches for more information) and via
MIDI (please see the MIDI table at the end
of this manual for more information) without
connecting to Architect. Device Patches
can be recalled at any point by double
clicking on the patch in the patches panel
or right clicking on the patch and selecting
"Load Patch".
Local Patches are saved on your computer, rather than on your amplifier. Local
Patches can be accessed in the patches panel on the right-hand side of the amp
page. You can save as many Local Patches as you like and these can be recalled
at any point by double clicking on the patch in the patches panel or right clicking
on the patch and selecting "Load Patch".
Note: Device Patches can be saved as Local Patches by right clicking on the
patch and selecting "Save as Local Patch". Local Patches can be saved to your
Amped 3 by right clicking on the patch and selecting "Save Patch to Device".
Random Preset Generation
Click on the 'Die' icon to generate a random amp preset. All front panel controls
will be randomised.
17