Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Machine does not cool:
• Check that the power plug is properly inserted and the appliance has electrical energy.
• The safety device of the compressor comes into action: wait 5-10 minutes before restarting the machine. Rapid and
continued start-up attempts do nothing but prolong the period of inactivity of the machine.
• Check that the machine is correctly positioned with the ventilation grids (6) free of any obstructions.
• Check that the machine is not running a storage cycle (LED (11a,b,c,d) flashing) that stops the compressor.
• Check that when the machine (switch (10)) turns on, the control panel shows the correct initialization procedure by
turning on all LEDs in sequence.
The paddle does not turn:
• Check that the paddle (5) is properly attached to the tube and locked with a special locking ring (4).
• Make sure it is free from obstacles that prevent it from rotating.
• Make sure the lid is closed in the correct position: a safety device stops the paddle when the lid is opened.
• Check that the LED paddle (2a) is not flashing. In this case, press the button (2) twice to restart the paddle. Make
sure that the mixture is not too thick to prevent the rotation of the paddle.
• Make sure that the machine is not running a storage cycle (LEDs (11a-b-c-d) flashing) that stops the paddle.
The machine is noisy:
• Some noise is part of the normal operating specifications, but if it becomes excessive contact the Service Centre to
avoid further and more serious problems.
The water discharge pipe leaks:
• Replace the gaskets. Two additional gaskets sets (16) are provided with the machine. Lubricate the gaskets before
fit the tap (9) into the water discharge tube.
The plastic sleeve (17) on the lower part of the paddle is to easy to separate.
• Replace the gasket with the new one. Four additional gasket (15) are provided with the machine.
The paddle does not scrape properly the sides of the bowl.
• Check that the scrapers (18), (19) and (17) are not damaged or worn. An additional set is provided with the machine.
• Check that the resilient pads (20) are not distorted. If they are distorted replace them. An additional set is provided
with the machine.
BLADE ACTIVATION
COMPRESSOR ACTIVATION
PROGRAM ACTIVATION
Storage ACTIVATION
TURN OFF FROM PROGRAM
TURN OFF FROM Storage
PROGRAM CHANGE
Storage CHANGE
PROGRAM ACTIVATION FROM Storage*
PROGRAM ACTIVATION FROM Storage***
* If storage is activated after a program.
** To activate the program whose LED is flashing, first select a different program.
*** If storage is activated without running programs.
16
ACTION
English
KEY COMBINATION
2
1
11
1+2 (3 seconds)
11 (3 seconds) then 1 and 2
11 (3 seconds)
11
12
11**
11
Publicidad
