Nemox GELATO 5+5K TWIN CREA i-Green Instrucciones Para El Uso página 9

FIRST USE
• Place GELATO 5+5KTWIN CREA I-GREEN on a flat surface, make sure that the ventilation grids (6) are not
obstructed. Leave a minimum clearance of 10 cm. around the ventilation grids.
• During use, the appliance must be kept clear of walls or furniture so as to not obstruct the inflow and outflow of
cooling air. The escape of warm or hot air is an integral part of the operation of the device, that exchanges heat with
the outside for refrigeration.
• Leave the machine in a horizontal position for 8 hours or more before first use, as if it has been tilted during transport,
the cooling agents must re-settle in the correct position.
• Before starting to use the machine, carefully clean the parts that are in direct or indirect contact with processed foods
(bowl, mixing paddle, paddle inserts, locking ring, lid etc).
• Hygiene is extremely important when dealing with food. Carefully follow the provisions of hygiene standards
applicable in your country (HACCP or equivalent).
PREPARING THE MIXTURE
Select the recipe and prepare the mixture, paying attention to the following:
• Handle the ingredients as required by the hygiene standards applicable in your country (HACCP or equivalent).
• For the preparation of gelato and sorbets, do not introduce more than 1.25kg of mixture each group, in order to
allow for proper volume increase while mixing.
• For the preparation of Granitas, the maximum recommended amount is 1kg.
• It is recommended to pour the mixture at a temperature between +10°C and +20°C. Higher temperatures may also
considerably increase the processing time.
HOW TO USE
• GELATO 5+5K TWIN CREA I-GREEN have two identical, completely autonomous and independent groups: the
operation of the single group is illustrated here.
• Check that the voltage indicated on the data plate corresponds to the local network. Insert the power plug into the
socket and switch on the main switch (10); the power light (21) will indicate the presence of voltage.
• The electronic board will run an initialization check, triggering all the LEDs on the control panel in sequence.
• Check that Water discharge tube (8) is closed with the water discharge tap (9) until i is fully locked.
• Insert the mixing paddle (5) in the bowl, turning it clockwise until it is positioned in the bottom of the bowl.
• Tighten the locking ring (4) to the bottom so that the mixing paddle is securely attached.
• Pour the previously prepared mixture.
• Close the lid (3).
MANUAL MODE
• Start the cooling system by pressing the Button (1); the LED (1a) will light up.
IMPORTANT: if the machine is turned off due to sudden and temporary suspension of power supply or incorrect
operation using the power keys of the refrigerant, wait a few minutes before restarting.
• Press button (2) to start the paddle; the LED (2a) lights up, the production cycle begins. The preparation time varies
depending on the quantity, initial temperature of the mixture, product type (creamed, sorbet or Granita) and ambient
temperature.
IMPORTANT: The movement of the paddle is entirely independent of the cooling system. A safety device stops the
movement of the paddle when the lid is lifted.
If the lid remains raised for prolonged periods, the cooling system will continue to operate. Consequently, when the
lid is lowered again the paddle may not start or stop due to the excessive consistency of the mixture. In this case, the
electronic control will permanently stop the paddle and LED (2a) will flash to indicate the fault.
If the preparation is not yet complete, turn off the compressor by pressing the button (1) and the paddle via the button
(2), wait until the mixture becomes softer and restart production.
• According to the recipe and the amount of ingredients used, average production time is 15/20 minutes.
• Through the opening (3a) on the lid, you can add additional ingredients (e.x. to make ripple gelato during the last
preparation phase).
• When the preparation has reached the desired consistency, turn off the cooling system by pressing button (1) and
stop the paddle by pressing button (2). To easily remove the preparation from the bowl, remove the mixing paddle
(5) by unscrewing the special fixing ring nut (4).
English
9