Bandwidth Limit Control; Return To Zero - Keysight U1610A Guia Del Usuario

3 Using the Oscilloscope
Before inversion
Figure 3-2

Bandwidth limit control

Press
bandwidth for a channel to 10 kHz or 20 MHz. For waveforms with frequencies
below the bandwidth limit, turning on this control removes unwanted
high-frequency noise from the waveform.

Return to zero

Press
both channels.
48
Waveform before and after inversion
and press
Bandwidth limit
> to return the vertical offset to zero for
After inversion
repeatedly to set the maximum
Keysight U1610/20A User's Guide