Cursor Measurement Controls - Keysight U1610A Guia Del Usuario

3 Using the Oscilloscope

Cursor Measurement Controls

Cursors are horizontal and vertical markers that indicate x-axis values for
timebase measurements and y-axis values for voltage measurements respectively.
You can use cursors to make custom voltage or time measurements on
oscilloscope signals.
Press
Figure 3-10
The X-cursor measurement places two vertical lines across the displayed
waveform, which adjust horizontally and indicate time relative to the trigger point
for all sources except math FFT (frequency is indicated).
The Y-cursor measurement places two horizontal lines across the displayed
waveform, which adjust vertically and indicate values relative to the waveform
ground point.
76
to access the cursor function menu.
Cursor function menu
Keysight U1610/20A User's Guide