Publicidad
Idiomas disponibles
Idiomas disponibles
3
Using the Oscilloscope
Custom Line
Press
you want to trigger. This is only applicable for the Line trigger mode.
Nth Edge trigger
The Nth Edge trigger allows you to trigger on the Nth edge of a burst that occurs
after a specified idle time.
Source
See
Slope
Toggle
oscilloscope count the waveform rising or falling edges. The oscilloscope will
trigger when the Nth edge has been detected after the idle time has been
satisfied.
Idle time
Press
greater than the largest width of the burst, and smaller than the longest idle time
(high or low).
In the example below, the idle time must be less than A and greater than B or C.
The idle time is considered whether it is low (as shown) or high.
58
and use the
"Source"
on page 55.
to select the Rising ( ) edge or Falling ( ) edge to make the
and use the
or
key to select the line number on which
or
key to set an idle time, which must be
Keysight U1610/20A User's Guide
Publicidad
