Keysight U1610A Guia Del Usuario página 86

Specify the channels displayed after autoscale
Toggle
autoscales.
– All
– Displayed Ch.
Preserve the acquisition mode during autoscale
Toggle
switched to Normal or left unchanged when autoscale is performed.
– Normal
– Preserve
Return to the previous menu
Press
Run/Stop
Press
– Continuous mode – You are viewing multiple acquisitions of the same signal
Keysight U1610/20A User's Guide
to set which channels will be displayed on subsequent
The next time you press
requirements will be displayed.
The next time you press
examined for signal activity.
to choose whether to allow the acquisition mode to be
The handheld scope will switch to the Normal acquisition mode whenever
is pressed.
The handheld scope will remain in the acquisition mode you have chosen when
is pressed.
to return to the previous menu.
to toggle between continuous running mode or stopped mode.
similar to the way an analog oscilloscope displays waveforms. "Trig'd" is
indicated on the status line if the triggering mode is set to the Normal or
Single acquisition.
Using the Oscilloscope
, all channels that meet the autoscale
, only the channels that are turned on will be
3
83