Publicidad
Idiomas disponibles
Idiomas disponibles
Inside view
8
7
6
Fig. 4: Inside view
1
Cable glands *
2
Solar button
3
Terminals
n 3 and 4: Downgrade input
n 5 and 6: External shunt release switching
output
4
Terminals to connect the data line (for Mod-
bus RTU)
5
MCU (MENNEKES Control Unit)
6
DIP switch
7
Connection for the MENNEKES configuration
lead
8
Terminals for voltage supply
* Additional cable glands are located on the top
and bottom.
3.5
Solar charging modes
The product has 3 charging modes (Standard
mode, Sunshine mode, Sunshine+ mode).
Standard mode
Charging occurs at maximum power. Mains power
is used for charging unless there is a sufficient
1
amount of excess energy.
2
Sunshine mode
The charging power is dependent on the excess
3
energy from the photovoltaic system. Solar energy
4
exclusively is used for charging. The charging pro-
cess starts if there is a sufficient amount of energy
available to charge the vehicle at 6 A per phase.
Sunshine+ mode
The charging power is dependent on the excess
5
energy from the photovoltaic system. Regardless of
how much current the photovoltaic system is feed-
ing at the time, the vehicle is provided with min-
imum charging current at all times (if necessary
through mains power). The minimum charging cur-
rent (standard: 6 A per phase) can be adjusted us-
ing the configuration tool (a qualified electrician is
required).
3.6
The LED information panel shows the operating
status of the product (e.g. standby, fault).
Standby
Detailed information regarding the Sun-
shine mode and Sunshine+ mode can be
found in chapter:
1 "6.2.3 Solar charging" [
LED information panel
Symbol
Meaning
lights up The product is ready for use. No
vehicle is connected to the product.
EN
22]
}
7
Publicidad
