Interpump Group SWS71 Manual De Reparación página 18

- Couple the con-rod caps to their shanks,
referring to the numbering (Fig. 9, pos. ).
Note the correct assembly direction of the caps.
- Fasten the caps to their respective con-rod shanks by
means of M8x1x48 screws (Fig. 10) lubricating both the
underhead and the threaded shank, proceeding in two
different stages:
1. Manually turn the screws until they begin to
tighten
2. Tightening torque
Alternatively, ensure:
1. Pre-tightening torque
2. Tightening torque
- After having completed tightening operations, check that
the con-rod head has a side clearance in both directions.
- Insert the new piston guide seal rings as far as possible
into the relative seat on the pump casing (Fig. 11),
following the procedure described:
use the tool code 27904900 composed of a tapered bush
and a buffer. Screw the tapered bush into the hole in the
piston guide (Fig. 11/a), insert the new seal ring on the
buffer as far as it will go (determined by the height of the
buffer) into its seat on the pump casing (Fig. 11/b), remove
the tapered bush (Fig. 11/c).
Fig. 8
Fig. 9
30 Nm
10-15 Nm
30 Nm
Fig. 10
18
POS. RING
Fig. 11
Fig. 11/a
Fig. 11/b