Elcometer NDT MTG6 Guia Del Usuario página 21

9 PIN LOCK
The 'PIN Lock' feature prevents the user from accidentally adjusting
the gauge settings.
To set a PIN code:
1 Press Menu/Setup/PIN Lock.
2 Set the four digit PIN code using the

softkeys to select 0 to 9 and the

 softkey to move to the next digit .
3 Press 'Ok' to set, 'Escape' to cancel or
'Adjust' to amend the PIN code.
When enabled, the following features are disabled and can not be
adjusted:
Menu/Limit Memories/Create Limit Memory
Menu/Limit Memories/Edit Limit Memory
Menu/Calibration/Calibrate
Menu/Calibration/Cal Method
Menu/Calibration/Cal Memory
Menu/Calibration/Factory Calibration
Menu/Calibration/Zero Set
Menu/Reset
Menu/Setup/Reading/Measurement Mode
Batch/New Batch/Batch Measurement Mode
Batch/New Batch/Batch Calibration
Batch/New Batch/Batch Limits/Create Limit Memory
Batch/Edit Batch/Delete Batch
Batch/Deleted Reading
To unlock the PIN code:
1 Press Menu/Setup/PIN Lock.
2 Enter the four digit PIN code using the
9 and the  softkey to move to the next digit .
3 Press 'Ok' or 'Escape' to cancel.
Note: Should the user forget or lose the PIN code, it can be disabled via
ElcoMaster . Using the USB cable supplied, simply connect the gauge to
a PC with ElcoMaster version 2.0.47 or higher installed and select
Edit/Clear PIN.
d
The  softkey will appear when the first 'X' is changed to a number.
www.elcometer.com
®
®
d

softkeys to select 0 to

d
R
en-20