Elcometer NDT MTG6 Guia Del Usuario página 5

4 GETTING STARTED
4.1 FITTING THE BATTERIES
Each gauge is supplied with 2 x AA alkaline
batteries.
To insert or replace the batteries:
1 Lift the latch on the battery compartment
cover and rotate anti-clockwise to remove
the cover.
2 Insert 2 batteries taking care to ensure
correct polarity.
3 Refit the cover and rotate the latch clockwise to close.
The battery condition is indicated by a symbol in the top right of the
display ( ):
Full symbol (orange) = batteries at full capacity

Empty symbol (red, flashing) = batteries at lowest

sustainable level
4.2 CONNECTING A TRANSDUCER
1 Align the red dot on the transducer
plug with the red dot on the base
of the gauge.
2 Push the transducer into the
gauge, ensuring that the connector
is fully engaged.
All dual element transducers which
can be connected directly to the
base of an MTG gauge - see
Section 17.1 'Transducers' on
page en-31 - are 'intelligent' transducers. The transducer frequency
and diameter will be identified automatically by the gauge.
Details of the transducer connected can be viewed at any time via
Menu/About/Transducer Information.
A transducer adaptor is available which enables other Elcometer
'non-intelligent', dual element transducers and other manufacturers'
transducers, to be used with the Elcometer MTG product range - see
Section 17.4 'Transducer Adaptor' on page en-35.
www.elcometer.com
R
+
+
en-4