Materials - Boston Scientific SureTek Burr Hole Cover Instrucciones De Uso

Burr Hole Cover Directions for Use
Removing the Burr Hole Cover
Cap Removal
1. While supporting the top of the Cap to control the release, insert the tip end of the Placement/Removal
Tool into an open Lead Exit Slot.
2. Gently pry upward on the Cap until it releases from the Base.
Retaining Clip Removal
3. To open the Slider and release the lead, use the tip end of the Placement/Removal Tool to gently push
down and back on the closure dimple on the Slider.
4. If desired, remove the lead using appropriate surgical techniques.
5. Insert the tip end of the Placement/Removal Tool into the Clip Release Hole on the Retaining Clip. The
tip of the Placement/Removal Tool should snap into place.
6. Gently push the Placement/Removal Tool partially toward the Slider and upward until the Retaining
Clip releases from the Base.
Base Removal
7. Unscrew the two screws from the base using the Screwdriver included in the kit or another compatible
screwdriver.

Materials

Part
Base
Retaining Clip
Cap
Bone Screws
Butterfly Holding Tool
Placement/Removal Tool
Disposable Screwdriver
Burr Hole Cover Directions for Use
91062297-02 6 of 251
Polyether ether ketone (PEEK)
PEEK
PEEK
Titanium
Polyetherimide, Silicone
Polyetherimide, Titanium
Polybutylene terephthalate (PBT) polycarbonate resin, stainless steel
Description