Wilo EMU TR 50-2 Serie Instrucciones De Instalación Y Funcionamiento página 307

1
2
8
Fig. 8: Mixer on the lowering device
2
10
11
8
Fig. 9: Mixer set down on the fixed limit stop
Installation and operating instructions Wilo-EMU TR/TRE 50-2 ... 120-1
Installation and electrical connection
Mounting the mixer on the lowering device
1
2
6
8
9
9
‡
Mixer hangs horizontally.
‡
Frame perpendicular to the guide pipe.
‡
Cable bracket is installed.
1. Slowly lower the mixer.
6
2. Insert the guide pipe in the frame without tilting.
NOTICE! The guide rollers are in contact with the guide pipe.
3. Version with quick-release axles:
Lower mixer until the frame is below the upper holder. Install the quick-release
axles and plastic rollers and secure them with linchpins!
Completing installation
1
1
2
8
12
10
11
12
‡
Mixer mounted on the lowering device
1. Slowly lower the mixer.
2. Attach the connection cable to lifting equipment using cable brackets.
The connection cable is routed safely with the lifting equipment (e.g. wire rope).
CAUTION! If no cable brackets are used to route the connection cable, ensure
that the connection cable is not pulled into the propeller!
3. Lower the mixer to the end of the guide pipe or until it reaches the fixed limit stop.
4. Secure the connection cable to the railing or hoisting gear to prevent it from fall-
ing!
5. Check the swivel range of the lowering device.
Check the complete swivel range of the lowering device. The mixer must not bump
into any structures (fixtures, basin wall). CAUTION! If the full swivel range cannot
be used, mechanically limit the swivel range!
6. Set the desired angle and install a screw to secure the lowering device against fur-
ther adjustments.
▶ Installation is complete. Lay the connection cable and make the electrical connec-
tion.
Hoisting gear
Lifting equipment
Frame
Guide pipe for lowering device
Upper holder of the lowering device
Hoisting gear
Lifting equipment
Guide pipe for lowering device
Connection cable
Cable bracket with snap hook, cable routing via lifting equipment
Cable bracket with snap hook, safeguard against falling
en
307