clage DSX Touch Instrucciones De Uso página 44

DSX Touch
4. CLAGE app "Smart Control"
EN
Initial operation
The Smart Control app can be connected to the DSX Touch either via Bluetooth or via
WLAN.
1. Make sure that the instantaneous water heater is supplied with voltage.
2. Install the control app on your tablet / smartphone. Search the Apple AppStore or
the Google Playstore for »CLAGE Smart Control« and install the app. Do not start
the control app yet.
Connecting via Bluetooth
1. Activate the Bluetooth function of your smartphone / tablet.
2. Start the Smart Control Control app and confirm all security prompts.
Note: No location-related data is processed. Activating and accepting the location
function is required due to new guidelines for all Android apps with Bluetooth func-
tion.
3. A message appears the first time the app is activated. Tapping on "OK" takes you
to the device configuration for manual setup (menu path: Main menu → Settings →
Devices). Tapping on "Demo" allows you to explore the app control. You can exit
demo mode again under (Main menu → Settings → Devices).
4. If no devices are listed yet, select "Bluetooth connections" and tap on "Search
devices...".
5. A maximum of ten Bluetooth devices found are then scanned and listed. If your
device is not included, repeat the scan.
6. Select your device and confirm with "OK".
7. Enter the Bluetooth PIN manually or scan the QR code. Both can be found on the
type plate under the panel at the bottom of the unit.
8. The unit is now connected to your smartphone / tablet. Check the function by
changing the temperature via your smartphone / tablet. The display of the device
must show the same value.
Connecting via WLAN
• Protect the appliance from unauthorised access by connecting it to an Internet-
connected IT infrastructure only if it is protected by a firewall.
• Protect the appliance against unauthorised access by using a secure Wi-Fi pass-
word. This should consist of letters, numbers and special characters and should not
be listed in the lexicon.
1. First connect the DSX Touch directly to your home network at the device control
panel and activate the REST API via Homeserver (for this, see section "Network" on
page 39).
2. Connect your smartphone to the same network and launch the app.
3. The app will automatically connect to the instantaneous water heater.
4. If not, go to the device configuration in the app (menu path: Main menu → Settings
→ Devices), select "DSX Server xxxx" and tap Connect.
5. The following text should be displayed: "The Home Server can be used".
44