Weh Proxeo PF-60 Manual De Uso Y Mantenimiento página 49

10 TROUBLESHOOTING
10.1 Quick Troubleshooting
If the appliance does not seem to work properly, read the instructions again and then
check the following table.
Problem
The cap of the powder con-
tainer doesn't unscrew
Powder leak through the
powder container cap
Possible Cause
The air polisher device is
connected to the turbine
and the powder container is
pressurised even if the pedal
isn't pressed
Cap not correctly tightened
Cap seal not properly posi-
tioned in its seat or worn
Powder residue in the thread
TROUBLESHOOTING
Solution
Disconnect the polisher
nozzle from the air polisher
device to depressurise the
internal circuit.
If the problem persists, free
the channel of the polisher
nozzle of any powder residue
using the cleaning needle
(read Chapter 6.5.1.2 on
page 28
)
Screw the cap correctly
Check the position of the cap
seal, or replace it if worn
Blow compressed air onto
the thread of the powder
container (read Chapter 5.3
on page 18 )
43