Publicidad
Idiomas disponibles
Idiomas disponibles
WORK CLAMP
See Figure 5.
The Vertical Work Clamp secures the workpiece to the table to
provide more stability and keeps the workpiece from creeping
toward the saw blade.
To install the Vertical Work Clamp do the following:
1.
Place the Clamp Shaft
Miter Base.
2.
Slide the clamp arm so the pad touches the workpiece.
3.
Rotate the knob
Clockwise to secure the workpiece.
C
To loosen, turn Counterclockwise.
DUST BAG
See Figure 6.
The Tool includes a Dust Bag
Port
on the Upper Blade Guard. Slide the Plastic Collar
D
onto the Dust Port on the back of the Saw Head.
NOTE: To remove the Dust Bag for emptying, simply reverse
the above procedure.
DUST PORT ATTACHMENT
See Figure 7.
The Tool includes a 2 1/2 inch Dust Port Adapter
attaches over the rear Dust Port on the Upper Blade Guard. It
can be used to connect your miter saw to a standard 2 1/2
inch vacuum or dust collection hose.
1.
The Dust Port Adapter Set-Screw
with the label located on the Dust Port
2.
Tighten the Set-Screw when aligned to the arrow found
on the label.
NOTE: DO NOT over tighten.
ASSEMBLY
in either hole
on the
A
B
that attaches over the Dust
PC4
that
PC9
should be aligned
F
.
E
B
D
PC4
PC9
F
13
A
C
Figure 5
Figure 6
E
Figure 7
Publicidad
