Publicidad
Idiomas disponibles
Idiomas disponibles
•
DO NOT allow familiarity with tools to make you
inflict serious personal
injury.
ALWAYS wear eye protection with side shields and marked to comply with ANSI Z87.1 Failure to do so could result in objects
•
being thrown into your eyes, resulting in possible serious personal
•
DO NOT use any attachments or accessories not recommended by the manufacturer of this
accessories not recommended can result in serious personal
ALWAYS clamp or bolt the compound miter saw to a workbench before starting any cutting operation.
•
NEVER operate the miter saw on the floor or in a crouched position. Failure to heed this warning can result in serious personal
•
injury.
•
ALWAYS tighten the miter lock knob and bevel lock handle securely before making a cut. Failure to do so could result in serious
injury due to movement of the control arm or miter table while making a
KEEP hands outside the no hands zone, at least 4 inches from the blade in order to avoid serious personal injury.
•
NEVER perform any cutting operation freehand (without holding workpiece securely against the
•
the workpiece if it slips or
•
When using a work clamp or C-clamp to secure the workpiece, clamp workpiece on one side of the blade
MUST remain free on one side of the blade to prevent the blade from binding in
cause motor stalling and
•
NEVER move the workpiece or make adjustment to any cutting angle while the saw is running and the blade is
can result in contact with the blade causing serious personal
DO NOT force the blade against the workpiece when cutting. Forcing the blade will cause a drop in motor RPM and increase the
•
risk of overheating the saw blade
You may use this tool for the following purposes:
•
Bevel cutting and compound cutting for crown moldings,
•
Cross cutting wood.
•
Cross cutting for moldings, door casings, picture frames,
NOTE: This saw is for cutting wood or wood-like
blade provided is not acceptable for cutting other materials.
CUTTING WARPED MATERIAL
See Figure 25.
When attempting to cut warped material, the CONVEX face
should be against the fence.
See Figure 26.
NEVER position a piece of warped material with the CONCAVE
face or edge against the fence. It will pinch the blade near the
completion of the cut.
To avoid a kickback and to avoid serious
personal injury, NEVER position the CONCAVE edge of bowed
or warped material against the fence.
OPERATION
careless.
twists.
kickback.
This situation could cause an accident resulting in serious personal
tips.
products.
Remember that a careless fraction of a second is sufficient enough to
injury.
injury.
cut.
workpiece.
injury.
etc.
etc.
The
22
tool.
The use of attachments or
fence).
The blade could grab
only.
The workpiece
The workpiece binding the blade will
injury.
rotating.
Figure 25
Figure 26
Any slip
Publicidad
