Delta 26-2312 Manual De Instrucciones página 30

EXPAND WORKTABLE AREA
This saw is designed to allow for large capacity cuts up to
(2 x 16 inch). In order to make these cuts you will need to
configure your saw appropriately.
DO NOT use an auxiliary table board which
will not fully support the workpiece during cutting operation.
Loosen the fence lock knob
(adjustable) fence completely out of its track and set to
the side. See Figure 39. (Both upper fences need to be
removed).
1.
Flip the back fence support tabs
Tabs are on both the left and right sides of the
D
lower (fixed) fence. These will function as your
workpiece backstop. See Figure 41.
2.
You will need to add a 2 x 12 inches (1 1/2 x 11 5/8
inches) auxiliary table board
capacity workpiece
NOTE: The Auxiliary Table Board should be as wide as the
lower (fixed) fence and secured to the lower fence using wood
screws, see Figure 40.
3.
Use the support tabs
workpiece before making any cuts.
OPERATION
. Slide the upper
A
into position.
D
to support your large
E
. See Figure 41.
F
to support the back of your
D
LOOSEN
TIGHTEN
A
Figure 39
Figure 41
30
B
Figure 40
D
F
E