Publicidad
Idiomas disponibles
Idiomas disponibles
BEVEL CUTS
To avoid personal injury, before turning
the saw power ON, check to make sure saw head and blade
will not make contact with the provided work clamp or fence
during the cutting operation. Position the work clamp and
fence to avoid contact with the miter saw head.
ALWAYS lock the bevel lock handle before
any cutting operation. Failure to do so may result in serious
personal injury.
See Figure 33 and 34.
1.
Follow Operation instructions "Non-sliding Cuts" in
previous section. Include the following adjustments
before cutting.
2.
Loosen fence lock knob
slide adjustable fence
bevel cuts. Once proper spacing is set, tighten fence
lock knobs.
3.
Lift the bevel lock handle
4.
While firmly supporting the saw head with one hand,
push back the bevel detent latch lever
the saw head left or right to the required bevel angle.
5.
If you are using one of the bevel detent positions, check
to make sure the bevel detent
positive stop plate.
6.
If you are using a bevel angle that is not one of the
common bevel detent positions, rotate the saw to the
desired bevel angle and use the bevel lock handle
to lock the head in place.
7.
Push down the bevel lock handle to lock bevel position.
COMPOUND MITER CUTS
To avoid personal injury, before turning
the saw power ON, check to make sure saw head and blade
will not make contact with the provided work clamp or fence
during the cutting operation. Position the work clamp and
fence to avoid contact with the miter saw head.
See Figure 34.
A compound miter cut uses a combination of a miter angle
adjustment and bevel angle adjustment. Use the instructions
from "MITER CUTS" and "BEVEL CUTS" sections to set your
bevel and miter angle before performing the "NON-SLIDING
CUTS" operation instructions above.
NOTE: The miter angle and bevel angle are dependent upon
each other. If you adjust one of these it will change the other.
ALWAYS check both angles after making any adjustments.
OPERATION
on left and right side, and
A
to allow proper spacing for
F7
.
F26
and swing
F21
locks into the
B
F26
26
LOCK
UNLOCK
A
UNLOCK
F26
LOCK
Figure 33
B
Figure 34
F21
F7
Publicidad
