Publicidad
Idiomas disponibles
Idiomas disponibles
Safety and Regulatory Information
Product Regulatory and Compliance
The DAQ970A/DAQ973A complies with safety and EMC requirements.
Refer to Declaration of Conformity at
Maximum transients on all inputs are limited to 1500 Vpk referenced to earth except for DAQM900A,
DAQM905A, DAQM907A and DAQM909A which are 0 Vpk. Measurement is rated for CAT 'none', and terminals
are not to be connected directly to mains. Do not use this equipment to measure circuits where transient over-
voltages could exceed this level.
Environmental Conditions and General Characteristics
Keysight DAQ970A/DAQ973A is designed for indoor use and in an area with low condensation. Tables below show
the general environmental requirements and general characteristics for this instrument.
Environmental condition
Temperature
Humidity
Altitude
Pollution degree
The electrical (power) requirements of the DAQ970A/DAQ973A are summarized as below.
General characteristics
Power supply
Power line frequency
Power consumption
Installation category
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE OR WET ENVIRONMENTS
Do not operate the instrument around flammable gases or fumes, vapor, or wet environments.
12
http://www.keysight.com/go/conformity
Requirement
Operating condition: 0 °C to 55 °C
Storage condition: –40 °C to 70 °C
Operating condition: Up to 80% RH at 40 °C (non-condensing), decreasing linearly to 50% RH at 55
°C (non-condensing)
Storage condition: Up to 50% RH at 55 °C (non-condensing)
Up to 3000m
2
Requirement
100 – 240 VAC (Mains supply voltage fluctuation is not allowed to exceed ± 10%)
50/60/400 Hz
75 VA Max
II
for the latest revision.
Keysight DAQ970A/DAQ973A User's Guide
Publicidad
