Simplicity Duke SYC102 Manual Del Usuario página 77

In exceptional cases, it is possible that for transportation reasons, the bumper bar of the mower is released and slides back towards
the seat. In such a case, proceed as follows:
f) Fit the bumper bar in the correct position:
► Open the hood.
► Slide the bumper bar consoles away from the seat – the correct position is clearly marked on the frame.
3.6.1f
► Properly tighten the bolts of the consoles on both sides of the mower and close the hood.
3.6.2 GRASS CATCHER
The grass catcher is supplied packed in a separate box. For transportation reasons some of its parts are demounted and they first
need to be assembled.
UNPACKING AND INSPECTING THE PACKAGE CONTENTS
Remove all packaging materials and carefully arrange the unpacked parts according to figure 3.6.2a.
1) Lid with top frame and sack
(2) Base
(3) Front tube
(4) Rear tube
(5) Contact spring of full grass catcher sensor
(6) Lower braces (grass catcher 320 l: 2×, grass catcher 380 l: 3×)
3.6.2a
(7) Top handle of the lid
(8) Dump lever handle
(9) Grass catcher hitches
(10) Lower hitch (for trailer)
(11) Joining material
A part of the grass catcher package are also spare break pins for the cutting blades (4 pcs). Keep these pins for future
use.
VIEW OF THE ASSEMBLED GRASS CATCHER
Positions correspond to the numbers in illustration 3.6.2a.
(1) Lid with top frame and sack
(2) Base
(3) Front tube
(4) Rear tube
(5) Contact spring of full grass catcher sensor
3.6.2b
(6) Lower braces
(7) Top handle of the lid
(8) Dump lever handle
ASSEMBLING THE GRASS CATCHER
► Screw the front tube under the lid of the top frame.
3.6.2c
► Attach the contact spring for the full grass catcher sensor on the left side of the top frame plate.
3.6.2d
► Screw in the rear tube into the grass catcher. For a grass catcher with a capacity of 320 l use the holes closer to the
front tube; for the grass catcher with a capacity of 380 l use the holes farther away from the front tube.
3.6.2e
77