Publicidad
Idiomas disponibles
Idiomas disponibles
FINAL INSTALLATION
4. Remove one of the four switch housing
mounting screws from the switch housing
mounting plate and loosen the other three
screws. (Do not remove.)
While holding the switch housing (I) under
the fan motor assembly (F), snap together
the wire connection plug with the 9-pin plug
from the switch housing (I).
Place the key holes on the switch housing (I)
over the three screws previously loosened
from the mounting plate. Turn the switch
housing (I) until the switch housing (I) locks
in place at the narrow section of the key holes.
Secure by tightening the three mounting screws
previously loosened and the one previously
removed.
5. Make sure the slot openings of the decorative
ring (J) are on top. Raise up the decorative
ring (J) and line up the four grooves with the
four screw heads on the switch housing (I).
Once lined up, slide the decorative ring (J)
and secure it to the switch housing (I) until
snug.
4
Switch
Housing
Mounting
Plate
5
14
Switch
Housing
Mounting
Screws
Publicidad
