10 Repairs; Restart Smartconnect; Replacing The Can Distributor - VOLTWERK SmartConnect 8 Instrucciones De Servicio

10 Repairs

10.1
Result
10.2
SmartConnect
Operating manual

Restart SmartConnect

Prerequisite
The DC disconnect is switched off (Off).
|
Restart the device.
1. Interrupt the auxiliary power supply for a few seconds.
2. Switch the auxiliary power supply on again.
3. Switch the DC disconnect to On.
Voltage
U < 300 V.
DC
300 V < U < 1000 V.
DC
The device has been restarted.

Replacing the CAN distributor

The replacement of this component must be documented so that it is
possible to trace which device has been replaced with which device, and
when. To enable this, the following data must be recorded and
communicated to the manufacturer:
Date of the replacement
|
Location of the replaced component (system, series, number)
|
Serial number of the replaced component
|
Serial number of the new component
|
Reason for the replacement (fault description, all fault messages
|
issued by the monitoring system).
Prerequisites
The DC disconnect is switched off (Off).
|
You have ensured that all connected SmartConnect devices are
|
voltage-free. Switching the DC disconnect to Off does not guarantee
that the device is free of voltage.
The central inverter is isolated.
|
The optional external string switch-off system is isolated.
|
The optional external signal transmitter is isolated.
|
10 Repairs
Device status
Standby mode.
The relays audibly switch on in
sequence.
67