VOLTWERK SmartConnect 8 Instrucciones De Servicio página 146

Result
SmartConnect
Operating manual
Restart the device.
1. Remove the RJ-45 plug of the communication cable (3) from the CAN
distributor.
The LED indicators of the CAN distributor do not light up.
Wait for a few seconds.
2. Reconnect the communication cable.
The device has been restarted.
The LED indicators on the CAN distributor light up.
If the LED indicators of the CAN distributor do not light up,
check the auxiliary voltage supply.
|
replace the device (see Chapter 10.2, page 67).
|
10 Repairs
69