SKYLOTEC SKYVEST Instrucciones De Uso página 15

Green permanent
Green
Flashing
Red
Flashing
Red Green flashing
First commissioning
The functional readiness and personal handling ability of the user are de-
cisive for the SKYVEST system. If you are unsure about the use or appli-
cation of the system, please contact Skylotec GmbH (www.skylotec.com).
Step 1
Charge battery
Please open the USB cover on the control module (see red circle) by
pulling off the USB protective cap at the right-hand end (top view) and
fully charge the battery using a USB C cable before using it for the first
time. The charging time takes approx. 1,5 hours depending on the char-
Slightly lift the USB protective cap on the side marked with the red arrow
and open it.
MAT-BA-0229-03_20240305.indd 15 MAT-BA-0229-03_20240305.indd 15
System is fully-
charged
System is in use
and will run for at
least another 8
hours
System is in
charge state
System is in use
and may run for
less than 8 hours
ger. After charging, please replace the
protective cover on the USB port. Al-
ways fully charge the battery before
use. The full runtime is only achieved
when the battery is fully charged.
This state only occurs
when the system is con-
nected to the charging
cable.
System active
System is charged
Stop using the system
and recharge the
system, otherwise it may
come to an unwanted
shut down.
15
26.03.2024 11:09:21 26.03.2024 11:09:21