Publicidad
Idiomas disponibles
Idiomas disponibles
English
3 Clamp nut
Serves to adjust the length of shaft.
4 Chain sprocket
The chain sprocket drives the saw chain.
5 Tensioning screw
The tensioning screw is used to adjust the
chain tension.
6 Oil filler cap
The oil tank cap closes the oil tank.
7 Guide bar
The guide bar supports and guides the saw
chain.
8 Saw chain
The saw chain cuts the wood.
9 Limit stop
Holds the pole pruner against the wood while
cutting.
10 Chain sprocket cover
Covers the chain sprocket and secures the
guide bar to the pole pruner.
11 Nut
The nut secures the chain sprocket cover to
the pole pruner.
12 Gauge bar
The saw chain can be positioned precisely
using the gauge bar.
13 Chain scabbard
The chain scabbard protects against contact
with the saw chain.
14 Battery
Supplies power to the pole pruner.
15 LEDs
The LEDs indicate the state of charge of the
battery and any faults.
16 Button
The pushbutton activates the LEDs on the
battery. The pushbutton activates and deacti‐
vates the Bluetooth® interface (if available).
17 "BLUETOOTH
®
" LED (only for batteries with
)
The LED indicates the activation and deacti‐
vation of the Bluetooth® interface.
18 Locking lever
The locking lever holds the battery in the bat‐
tery compartment.
4
The cover is part of the motor housing. Only remove the cover to install a Smart Connector 2 A and
store it safely for later re-installation. Always use the pole pruner with the cover or Smart Connector 2
A installed.
36
19 Battery compartment
The battery compartment holds the battery.
4
20 Cover
The cover is the placeholder for a Smart Con‐
nector 2 A.
21 Control handle
For holding and controlling the pole pruner.
22 Trigger lockout
The trigger lockout unlocks the trigger.
23 Release slide
The release slide is used to switch on the
pole pruner.
24 LED
The LED indicates the status of the pole pru‐
ner.
25 Clip
The clip is used to attach the carrying system.
26 Trigger
Switches the pole pruner on and off.
27 Air filter
The air filter filters the air entering the engine.
28 Base
The machine support is used to deposit the
pole pruner on the ground.
# Rating plate with machine number
3.3
Symbols
Meanings of the symbols that may be on the pole
pruner and battery:
The clamp nut is unscrewed in this posi‐
tion. The shaft can be extended.
The clamp nut is locked in this position.
The shaft cannot be extended.
This symbol marks the oil tank for saw
chain oil.
This symbol shows the direction of
rotation of the saw chain.
Rotate in this direction to increase the saw
chain tension
1 LED lights up red. The battery is too
warm or too cold.
This icon marks the release slide.
3 Overview
0458-038-9802-A
Publicidad
