Publicidad
Idiomas disponibles
Idiomas disponibles
English
► Hold the guide bar nose up and turn the ten‐
sioning screw (2) clockwise until the following
points apply:
– The chain sag 'a' in the center of the guide
bar is 1 - 2 mm.
– The saw chain can still be pulled easily
along the guide bar with two fingers.
► Hold the guide bar nose up and tighten down
the nut (1) firmly.
► If the chain sag 'a' in the center of the guide
bar is not 1 - 2 mm: Readjust the saw chain
tension.
8.8
Filling Up with Saw Chain Oil
The saw chain oil lubricates and cools the rotat‐
ing chain.
► Switch off the pole pruner and remove the bat‐
tery.
► Place the pole pruner on a level surface so
that the oil tank cap faces up.
► Use a damp cloth to clean the oil tank cap and
the area around it.
► Swing the grip on the oil tank cap to the verti‐
cal position.
► Turn the oil tank cap counterclockwise as far
as it will go.
► Remove the oil tank cap.
► Fill up with saw chain oil, taking care not to
spill any oil and not to overfill the tank.
► If the grip on the oil tank cap has dropped into
the closed position: Raise the grip until it is
vertical.
1
2
► Place the oil tank cap in the filler opening so
that mark (1) lines up with mark (2).
48
► Press the oil tank cap down and rotate it clock‐
► Check to see if the oil tank cap can be pulled
► If the oil tank cap cannot be pulled upwards
If the oil tank cap can be pulled upwards and off,
perform the following steps:
► Place the oil tank cap in the filler opening – in
► Press the oil tank cap down and rotate it clock‐
► Press the oil tank cap down and rotate it coun‐
► Now try again to close the oil tank.
► If the oil tank still cannot be closed properly:
9.1
1
► Insert the battery (1) up to the limit stop into
3
9.2
► Place the pole pruner on a level surface.
9 Removing and Fitting the Battery
wise as far as it will go.
The oil tank cap snaps into place. The mark
(1) points to mark (3).
upwards and off.
and off: Fold down the grip on the oil tank cap.
The oil tank is closed.
any position.
wise as far as it will go.
terclockwise until mark (1) points to mark (2).
Do not use your pole pruner and contact a
STIHL dealer for assistance.
The pole pruner is not in a safe condition.
9
Removing and Fitting the
Battery
Inserting the Battery
1
2
the battery compartment (2).
The battery (1) engages with a click and is
now locked.
Removing the Battery
1
2
0458-038-9802-A
Publicidad
