Stihl HTA 150.0 Manual De Instrucciones página 51

12 Using the Pole Pruner
12 Using the Pole Pruner
12.1 Adjusting the length of shaft
(HTA 160.0)
The shaft can be adjusted to different lengths to
suit the application as well as the user's height
and reach.
► Switch off the pole pruner and remove the bat‐
tery.
max 45°
► Turn the clamp nut (1) a half-rotation
towards .
► Adjust the shaft (2) to the required length.
► Turn the clamp nut (1) in direction as far as it
will go.
► Check that the shaft (2) cannot be shifted any
more ant that the clamp nut (1) is twisted tight
in direction as far as it will go.
The shaft length is properly adjusted if the
shaft (2) cannot be pushed in or pulled out and
the clamping unit is screwed tight as far as it will
go in direction of .
12.2 Aligning the clip (HTA 160.0)
The clip can be moved to different positions
depending on the shaft length.
► Switch off the pole pruner and remove the bat‐
tery.
1
2
► Press clip (1) together and move on the han‐
dle hose (2), ensuring that the following condi‐
tions are met:
– If the shaft has been retracted: a = 15 cm
– If the shaft has been fully extended:
b = 50 cm
0458-038-9802-A
12.3
2
► Put on the shoulder strap (1).
1
► Adjust the shoulder strap (1) so that the cara‐
Other approved carrying systems are listed in
this User Manual,
12.4
► Connect the carrying ring (2) to the carabi‐
Low limbing
a
► Hold the pole pruner with one hand by the
b
► Hold the pole pruner with the other hand on
Fitting and Adjusting the Shoul‐
der Strap
biner (2) is about a hand's width below your
right hip.
22.1.
Holding and controlling the pole
pruner (HTA 150.0)
ner (1).
control handle – wrap your thumb around the
control handle.
the loop handle such that your thumb holds
the loop handle.
English
1
2
1
2
51