Sears Kenmore 72471 Manual Del Usuario página 30

Care and Cleaning (cont,0oo )
Broiler Pan and Grid
After broiling, remove the
broiler pan fi'om the oven
or broiler compartment
(depending on your model).
Remove the grid from the
pan_ Carefully pour out
grease ft'om the pan into a
proper' containet_ Wash and
I I
! ' "-7" !
! i
rinse the broiler pan and grid in hot water-with a
soap-filled or' plastic scouring pa&
ff food has burned on, sprinkle the grid with detergent
while hot and cover with wet paper' towels or a dishcloth.
Soaldng the pan will remove burned-on foods.
"The broiler pan and grid may be cleaned with a
commercial oven cleaner.
Both the broiler' pan and grid can also be cleaned in a
dishwasher.
Do not store a soiled broiler pan and grid anywhere
in the range.
CAUTION: Do not clean the broiler pan or grid in
a self-cleaning oven.
Oven Shelves
Clean the shelves with an abrasive deanser or steel
wool. After' cleaning, rinse the shelves with clean water
and dry with a clean
clod:.
NOTE: Take the shelves out of the oven before you
begin the self-clean cycle.
Oven Bottom
The oven bottom has a
porcelain enamel finish.
To make cleaning easier;
protect the oven bottom
fiom excessive spillovers by
placing a cootde sheet on
the shelf below the shelf"
you are cooldng on_ You
can use aluminum foil if
you do not cover the whole sheIf[ This is particularly
important when baldng a fiuit pie or other foods with
a high acid content. Hot fruit fillings or' other foods
that are highly acidic (such as tomatoes or sauerkraut
and sauces with vinegar or lemon juice) may cause
pitting and damage to the porcelain enamel surface
and should be wiped up immediately.
To clean up spiUovers, use soap and water, an abrasive
cleaner or soap-filled steel wool pad. Rinse well to
remove any soap before self-cleaningo
3O
Surface Light and Starter
(on some models)
CAUTION: Do not
touch the bulb with wet
hands or when bulb is
hot. Never wipe tile
light area with a wet
doth. Electrical power
must he shut offffyou
have to replace a bulb.
Carlo
up
Starter
To replace the starter:
I. Open the canopy and remove the bulb as
explained above.
2. Grasp the starter, turn it counterclockwise about
one-quarter turn and lift out° Replace with one of
the same wattage,
3, Replace the bulb and lower the canopy°
To replace the bulb:
1, With one hand at each
Light bulb
end of tile hinged
canopy, grasp it by the
front edge and flip it up.
2. Remove the fluorescent light bulb. Replace the bulb
with one of the same length and wattage.
3. Lower the canopy,