Publicidad
Idiomas disponibles
Idiomas disponibles
10
Index of parameters
FACTORY
PARAM.
DEFAULT
see chap. 12 Selecting automation system model
Automatic closure after pause time (from gate completely open)
Automatic gate closing after mains power outage
Selecting step mode control function (PP)
Condominium function for partial open command (PED)
Enabling operator present function
Setting deceleration during opening (and closing for TW90/800 - TW90/820)
Setting deceleration during closing (High Speed - Reversible only)
Setting gate open limit switch constant speed approach distance
Setting gate closed limit switch constant speed approach distance
Partial opening adjustment (%)
Adjusting automatic closing time after partial opening
COR output operating mode
Setting automatic closing time
Enabling of management for opening with automatic re-closure exclusion
Tolerance on opening stop
Tolerance on closing stop
Advance on stop on full opening
Advance on stop on full closing
Setting reverse time after activation of sensing edge or obstacle detection (crush
prevention)
Setting motor torque
Setting obstacle impact force sensitivity
Setting start acceleration during opening (and closing for TW90/800 - TW90/820)
Setting start acceleration during closing (High Speed - Reversible only)
Enabling maximum torque boost at start of manoeuvre
Setting motor torque during position recovery
Setting opening speed (and closing for TW90/800 - TW90/820)
Setting closing speed (High Speed -Reversible only)
Setting end of manoeuvre constant approach speed
Setting number of automatic closure attempts after activation of sensing edge or
obstacle detection (crush protection)
Setting photocell mode during gate opening (FT1)
Setting photocell mode during gate closing (FT1)
Photocell (FT1) mode with gate closed
Setting photocell mode during gate opening (FT2)
DESCRIPTION
PAGE
67
67
67
67
67
67
68
68
68
68
68
68
68
68
68
68
69
69
69
69
69
69
69
69
70
70
70
70
70
70
70
70
71
71
71
71
65
Publicidad
