Publicidad
Idiomas disponibles
Idiomas disponibles
When the battery voltage drops under the threshold selected with par.
automatically opens the barrier's boom and accepts only a closing command.
It accepts only closing commands even if the ORO input is active and if the parameter is
When the battery voltage drops to the threshold selected with par.
automatically closes the gate and accepts only one opening command
Selection of the battery type and consumption reduction
NOTE: An INCORRECT setting of this parameter, when there is no mains voltage, blocks the functions and the display
shows the message
Battery 24V
Battery 24V
to increase the battery life.
Battery 24V
consumption.
Battery 24V
Restoring factory default values
NOTE This procedure is only possible is NO data protection password is set.
• The default factory settings have now been restored.
Note:
version appears on the display, press and hold down the
N.B.: The values shown in the table are indicative only.
HW version.
Year of manufacture.
Week of manufacture.
Serial number.
FW version.
View manoeuvre counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Manoeuvres performed.
Example:
View manoeuvre hour counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Manoeuvre hours.
Example:
View control unit days on counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Days with unit switched on.
Example:
74
(if set to
or
(2x12V
(2x12V
(2x12V
(2x12V
) with external charger
Warning! Restoring default settings cancels all settings made previously
except for parameter
P1
are suitable for the installation.
P2
• Press and hold the PLUS + and MINUS - button until the unit switches on.
x4 s
• The display flashes after 4 s
x100 = 1.234.500 manoeuvres.
= 123 hours.
= 123 days.
and the battery is 2x12V
) or an error alert
. No reduction in performance. Maximum battery consumption
,
,
(UP ARROW) and
Example:
to
multiplied by 100.
to
.
to
.
, after a 5 s pre-flashing, the control unit
.
the control unit, after a prelamping of 5s,
.
,
: after restore, check that all parameters
.
(DOWN ARROW) buttons for 4s.
to
.
Publicidad
