Publicidad
Idiomas disponibles
Idiomas disponibles
LEARNING PROCESS
CAUTION: The wall control can be
programmed to multiple receivers or fans. If this
is not desired, turn wall switch off to any other
programmable receiver or fan.
IMPORTANT: This fan has been pre-paired
at the factory and the fan can to use now. If you
have two or more fans, please follow steps
below to control each fan independently. Also
follow steps below to re-pair the wall control
when needed.
NOTE: The dip switch has been set on "0"
position for your convenience. If you want to
re-pair the remote, please set the dip switch on
"1" position.
1. Within 30 seconds of turning AC power on,
press and hold the "LEARN" button for 3
seconds. The receiver will make sound, Bi,
twice. The ceiling fan turns on 1 speed. The
fan has completed the pairing process with
the wall control and is ready for use.
2. If user cannot finish the setting within the 30
seconds time frame, the main power must
be turned off and re-started again. This will
TESTING YOUR FAN
It is recommended that you test fan before finalizing installation. Restore power from circuit box . Test
fan speeds. If the wall control operate(s) all of the functions of the fan, battery has (have) been installed
correctly. If the wall control do (does) not operate all of the fan functions, refer to "Troubleshooting"
section to solve any issues before contacting Customer Service.
Fan must be on LOW before setting the fan in reverse. Use button to recirculate air depending on the
season. A ceiling fan will allow you to raise your thermostat setting in summer and lower your thermostat
setting in winter without feeling a difference in your comfort.
NOTE: If the wall control interferes with other appliances, activate a new code on the wall control by
turning the power off first. Go to the instructions for the LEARN button LEARNING PROCSS.
reset the unit. Repeat step 1 until the LEARNING
feature is activated as indicated. If you would like
to set the dip switch back to the "0" position after
a learning, please re-pair the remote by following
the learning process again.
NOTE: The learning process causes any installed
fan within range to memorize a wall control. Wall
control can learn five fans. All controls must be
within 30 feet of the fan.
1
LEARN
LEARN
Button
15
Faceplate
Wall
Control
Dip Switch
Publicidad
