Overheating Mode; Cleaning; Maintenance; Legal Information - Ottobock C-Leg 3C98-3 Instrucciones De Uso

Safety mode can be disabled by connecting then disconnecting the battery charger. If the
product switches into safety mode again, this means a permanent error exists. The product must
be inspected by an authorised Ottobock Service Centre.

9.4 Overheating mode

When the hydraulic unit overheats due to uninterrupted, increased activity (e.g. extended walking
downhill), damping is increased along with the rising temperature in order to counteract the over­
heating. When the hydraulic unit cools down, the product switches back to the damping settings
that existed before the overheating mode.
Overheating mode is indicated by a long vibration every 5 seconds.
When overheating mode is active, it is not possible to switch to a MyMode, display the current
battery charge level or change the prosthesis settings. In addition, the resistance in the flexion
direction is not reduced when the sitting function is active.
Overheating mode is not activated in the MyModes.

10 Cleaning

1) Clean the product with a damp cloth and mild soap (e.g. Ottobock 453H10=1 Derma Clean)
when needed.
2) Dry the product with a lint-free cloth and allow it to air dry fully.

11 Maintenance

INFORMATION
This component was tested for three million load cycles in accordance with ISO 10328.
Depending on the activity level, this corresponds to a service life of three to five years.
The duration of use can be individually extended depending on the intensity of use by perform­
ing regular service inspections.
Regular service inspections are recommended in the interest of the user's own safety, and in
order to maintain operating reliability and protect the warranty. These service inspections include
an inspection of the sensors and replacement of worn parts.
To have a service inspection carried out, please send the product as well as the battery charger
and power supply unit to an authorised Ottobock Service Centre.

12 Legal Information

All legal conditions are subject to the respective national laws of the country of use and may vary
accordingly.

12.1 Liability

The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregard of this document, particularly due to improper use or unauthorised
modification of the product.

12.2 Trademarks

All product names mentioned in this document are subject without restriction to the respective
applicable trademark laws and are the property of the respective owners.
All brands, trade names or company names may be registered trademarks and are the property of
the respective owners.
Should trademarks used in this document fail to be explicitly identified as such, this does not justi­
fy the conclusion that the denotation in question is free of third-party rights.
62 | Ottobock