Display Of The Current Charge Level - Ottobock Meridium 1B1 Instrucciones De Uso

Ocultar thumbs Ver también para Meridium 1B1:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 147

6.3 Display of the current charge level

INFORMATION
The charge level cannot be displayed during the charging process.
Beep signal
5x short
4x short
3x short
2x short
1x short
1x short
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app or using the remote control, there are
no beep signals (see Page 60).
Display of the current charge level using the cockpit app:
Once the cockpit app has been started, the current charge level is displayed in the bottom line of
the screen:
Display of current charge level using remote control:
The current charge level is displayed in the status bar of the remote control when it is connected
and switched on:
48 | Ottobock
1) Turn the prosthesis by 180° (the sole of the foot must face up).
2) Hold the prosthesis still and wait for beep signals.
Prosthetic foot with knee joint:
The beep signal for the knee joint sounds after approx.
2 seconds.
The beep signal for the prosthetic foot sounds after approx.
4 seconds.
Prosthetic foot without knee joint:
The beep signal for the prosthetic foot sounds after approx.
2 seconds.
Vibration signal
3x long
5x long
1.
38% – battery charge level of currently connected pros­
thesis
1.
– Charge level of battery for currently connected pros­
thesis
– Prosthesis is being charged
2. 68% – Charge level of battery for currently connected pros­
thesis, as a percentage
Battery charge level
more than 80%
66% to 80%
51% to 65%
36% to 50%
20% to 35%
less than 20%

Publicidad

Tabla de contenido
loading

Tabla de contenido