Charging The Prosthesis Battery; Display Of The Current Charge Level - Ottobock Meridium 1B1 Instrucciones De Uso

6.2 Charging the prosthesis battery

6.3 Display of the current charge level

INFORMATION
The charge level cannot be displayed during the charging process.
Beep signal
5x short
4x short
3x short
2x short
1x short
1x short
Display of the current charge level using the cockpit app:
Once the cockpit app has been started, the current charge level is displayed in the bottom line of
the screen:
Display of current charge level using remote control:
The current charge level is displayed in the status bar of the remote control when it is connected
and switched on:
1) Open the charging receptacle cover.
2) Connect the charging plug to the charging receptacle of the
product.
INFORMATION: Take note of the plug direction!
→ The correct connection of the battery charger to the product is
indicated by feedback (see Page 69).
3) The charging process starts.
→ Once the product battery is fully charged, the yellow LED on the
battery charger turns off.
4) Disconnect the product after the charging process is complete.
→ This is followed by an electronics self-test which is confirmed by
feedback (see Page 69).
5) Close the charging receptacle cover.
1) Turn the prosthesis by 180° (the sole of the foot must face up).
2) Hold the prosthesis still and wait for beep signals.
Prosthetic foot with knee joint:
The beep signal for the knee joint sounds after approx.
2 seconds.
The beep signal for the prosthetic foot sounds after approx.
4 seconds.
Prosthetic foot without knee joint:
The beep signal for the prosthetic foot sounds after approx.
2 seconds.
Vibration signal
3x long
5x long
1. 38% – battery charge level of currently connected pros­
thesis
Battery charge level
more than 80%
66% to 80%
51% to 65%
36% to 50%
20% to 35%
less than 20%
Ottobock | 47