CAMPAGNOLO NEUTRON Carbon Hub Manual De Uso página 30

• For every spoke (Fig. 6):
- insert the new spoke in the hole in the new rim;
- fit the plate on the spoke, keeping the concave part facing outwards and
position it in the special groove on the rim; when fitting a spoke on the LH
side of the wheel, the long side of the plate must face leftwards and vice
versa, as illustrated in figure 5.
- check that plates and barrels on the hub remain in position, then tighten
the nut.
Attention
After completing the operation, check that the flat spoke (aero) is oriented
in an aerodynamic position (Fig. 7).
WARNING!
When fitting the wheel, check that the plates remain in position since
an incorrectly positioned plate may cause irreparable damage to the
profile of the rim when tensioning the spokes. This damage could
cause the rim to unexpectedly fail, resulting in an accident, personal
injury or death.
• Perform these operations for all spokes.
• Following the operations described in Section 5 of the "Owner's Manual -
PART 1":
- Tighten and Settle the Spokes;
- Check centering and wheel dishing.
WARNING!
Check that the side of the rim does not show any sign of significant
wear, damage or deformation on the braking track, which could cause
the rim to unexpectedly break, resulting in an accident, personal
injury or death.
6 7
7