CAMPAGNOLO NEUTRON Carbon Hub Manual De Uso página 33

• Insert the new spoke (H - Fig. 15) in the hole in the hub.
• Fit the plate on the spoke, keeping the concave part facing outwards and
position it in the special groove on the rim; when fitting a spoke on the
LH side of the wheel, the long side of the plate must face leftwards and
vice versa, as illustrated in figure 16.
• Tighten the nut.
WARNING!
When fitting the wheel, check that the plates remain in position since
an incorrectly positioned plate may cause irreparable damage to
the profile of the rim when tensioning the spokes. This damage
could cause the rim to unexpectedly fail, resulting in an accident,
personal injury or death.
• Refit the hub, performing disassembly operations in reverse order.
Attention
When inserting the axle, be careful not to move the ball bearings out of
their seats.
Attention
After completing the operation, check that the flat spoke (aero) is oriented
in an aerodynamic position (Fig. 7 - Page 7).
• Following the operations described in Section 5 of the "Owner's Manual
- PART 1":
- Tighten and Settle the Spokes;
- Check centering and wheel dishing.
• After having replaced the spoke and tensioned and centered the wheel,
adjust the hub (see section 7).
10
15
H
16