CAMPAGNOLO NEUTRON Carbon Hub Manual De Uso página 36

• Insert the new spoke in the specific seat in the hub, turning the thicker
side (X - Fig. 21) of the cable end (A - Fig. 21) towards the inside.
• If necessary, reposition the overlapping spoke, making sure that the
overlap is correct where the two meet.
• Slightly open the spoke retainer ring, then refit it (Fig. 22).
Attention
After completing the operation, check that the flat spoke (aero) is orien-
ted in an aerodynamic position (Fig. 23).
• Following the operations described in Section 5 of the "Owner's Manual
- PART 1":
- Tighten and Settle the Spokes;
- Check centering and wheel dishing.
• After having replaced the spoke and tensioned and centered the
wheel, adjust the hub (see section 7).
21
X
A
22
23
13