Cardan Shaft - JF MIX 4000 CS Manual De Instrucciones

CARDAN SHAFT

Initially, it is necessary to verify is the cardan
length is adequate to the tractor that will
be used. Due to the variation in the distance
between the tractor PTO and the machine drive
shaft, it might be necessary to cut the cardan. In
order to perform this operation and verification,
proceed as follows:
PROCEDURE:
With the machine coupled, manoeuver the
tractor in a way that one of its rear tires gets
really close to the machine hitch, without
touching it (see the picture beside).
Disengage both parts and remove the plastic
protections.
Instructions Manual 21