JF MIX 4000 CS Manual De Instrucciones página 37

7.
Remove the nut and the bolt (P)
8.
Remove the nut and the bolt (Q), using a
36mm screwdriver.
9.
Remove the sensor (R)
10.
In order to assemble the new load sensor,
use the same procedure above, in reverse
order.
IMPORTANT!
a
fTer changing The rear load sensor
forgeT To TighTen The Two bolTs
,
Touch The nuT supporTing The weighT over The
. i
sensor n case This is noT done
sysTem will noT work properly
IMPORTANT!
w
hen assembling The Two sensors
wires are posiTioned according To The picTures
. (b
beside y looking aT The rear end of The wagon
They should be placed in The righT side
,
do noT
(k)
unTil They
,
The weighing
.
,
observe if The
,
).
Instructions Manual
Q
P
K
R
K
37