JF MIX 4000 CS Manual De Instrucciones página 22

ATTENTION: Turn off the tractor
and take the ignition key off
the panel before you start the
following procedure.
Couple the shaft bar (male side) onto the
machine and the tubular one (female side) onto
the tractor.
Place the cardan parts side by side (parallel) – as
shown in the picture beside.
In this position, there must be a clearance of at
least 30mm on each tip of the cardan.
Before you cut the cardan shaft, you should
consider all the possibilities of using it in its
original size. Try to adjust the tractor's shaft bar.
In case there are any enquiries, always consult
your tractor manual.
If there is no possibility of using it in its original
size, proceed with the cut, as follows:
Select in one of the cardan parts the desired
position of the cut (remember to leave a
clearance of 30mm).
Remove the cardan from the machine and the
tractor and perform the cut.
Use the first cut piece as a measure to cut the
other tip.
IMPORTANT!
T
he cuT pieces of The male and female cardan
musT have The same lengTh
The cuT on The leafleT affixed on The cardan
22
. s
ee insTrucTions for
.
Instructions Manual
SLACK:
30 mm
MÁQUINA
TRACTOR
HOLGURA:
30 mm